Table of Contents
Advertisement
10. Insert the DIMM into the connector by aligning the edges of the DIMM with the
11. Reinstall the air baffle (see "Installing the air baffle" on page 52 for more
12. Reinstall the power-supply cage.
13. Reinstall the left-side cover (see "Completing the installation" on page 96).
14. Reinstall the power supplies.
15. Reconnect the power cords and external cables.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 96.
Installing an optional ServeRAID adapter advanced feature key
To install an optional ServeRAID adapter advanced feature key, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the left-side cover (see "Removing the left-side cover" on page 48).
4. Rotate the adapter-retention brackets to the open position.
5. Pull up the power-supply cage handle, and then swing the power-supply cage
out of the server (see "Opening the power-supply cage" on page 55 for more
information).
6. Remove the air baffle from the server (see "Removing the air baffle" on page
51 for more information).
7. Open the retaining clip on each end of the DIMM connector.
Attention:
To avoid breaking the DIMM retaining clips or damaging the
DIMM connectors, open and close the clips gently.
8. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the outside of the server. Then, remove the DIMM from the
package.
9. Turn the DIMM so that the DIMM keys align correctly with the connector.
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly inserted; open the
retaining clips, remove the DIMM, and then reinsert it.
information).
on page 28.
Chapter 2. Installing optional devices
85
Advertisement
Table of Contents
