Table of Contents
Advertisement
2-6
Installing the Hard Disk Drive
Read the following guidelines before you begin to install the Hard disk drive:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the HDD is connected to the HDD connector on the backplane.
Follow these instructions to Hard disk drive:
1.
Press the release button.
2.
Pull the locking lever to remove the HDD tray.
3.
Slide hard disk into blank.
4.
Secure the hard drive to the tray with four (4) screws as shown. Do not over tighten thescrews.
Slide the blank into the bay until it locks into place.
5.
Engage the HDD Security Lock. For detail instruction, please see the following section.
Hardware Installation
5
2
4
1
5
- 20 -
3
4
Advertisement
Table of Contents
