Cli Command Set - Asus DS300f Quick Start Manual

ASUS Storage DS300j Quick Start Guide
Task 7: Setting Up the CLI Connection
The ASUS Storage DS300j unit has a Command Line Interface (CLI) to manage
all of its functions via your PC's terminal emulation program, such as Microsoft
HyperTerminal. This procedure uses the serial cable connection you made on
page 11.
You must use the serial connection to run the CLI for direct management of the
ASUS Storage DS300j unit. See "Chapter 3: Management" in the ASUS Storage
DS300j User Manual.
To set up a serial connection:
1. Change your terminal emulation program settings to match the following
specifications:
•
Bits per second: 115200
•
Data bits: 8
•
Parity: None
•
Stop bits: 1
•
Flow control: none
2. Start your PC's terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
When connected and ready, the CLI screen displays:
***********************************************
***********************************************
cli>
The cli> prompt on your screen indicates that you have a connection and the
CLI is ready to accept commands.

CLI Command Set

The CLI uses the following set of commands:
cable – Specifies the length of cable for optimal signal quality.
enclosure – Displays full information on the VessJBOD enclosure and its
components.
factorydefault – Restores factory default settings.
help – Use alone to see the list of commands. Use with a command to see a list
of options. Examples: enclosure -help or enclosure -h.
link – Displays the current status of the PHYs (links), error counter, expander and
attached SAS addresses.
ASUS SAS Expander v2.00.0000.xx
14