Position Selection - JVC RMP-2580U - Remote Controller For Color Domes Instructions Manual

POSITION SELECTION

Selecting a Desired Preset Position
CAMERA display POSITION display
REMOTE CONTROL UNIT REMOTE CONTROL UNIT
CAMERA POSITION
PO POWER WER
ALARM ALARM
AUTO
KEY LOCK KEY LOCK
CAMERA/POSITION CAMERA/POSITION
1 2 3
CAMERA CAMERA POSI-
TION
4 5 6
OPTION OPTION
1 2
7 8 9 AUTO AUTO AUTO AUTO
PAN PAN PATROL PATROL
0
CLEAR ENTER
/HOME
CLEAR button - button
ENTER button
NOTE
When TK-C675B cameras are used, make sure that the lower 4 digits inscribed on the serial number on their rear panels are as
shown below. Otherwise the cameras cannot be moved to the desired positions.
TK-C675BU: #0060 or after
When the serial number of a camera is other than the above, please consult your nearest JVC-authorized service agent.
Setting All Cameras to the Home Positions
CAMERA display POSITION display
REMOTE CONTROL UNIT REMOTE CONTROL UNIT
CAMERA CAMERA POSITION POSITION
POWER PO WER
ALARM ALARM
AUTO AUTO
KEY LOCK KEY LOCK
CAMERA/POSITION
1 2 3
CAMERA CAMERA POSI- POSI-
TION TION
4 5 6
OPTION OPTION OPTION OPTION
1 2
7 8 9 AUTO AUTO AUTO AUTO
PAN PAN PATROL PATROL
0
CLEAR CLEAR ENTER ENTER
/HOME /HOME
( REF. : Page 27 for the position presetting.)
RM-P2580 RM-P2580
F-1 F-2 F-3
POSITION
button
PAN/TILT
Numeric key
buttons
+ button
RM-P2580
F-1 F-1 F-2 F-2 F-3 F-3
CAMERA
button
PAN/TILT PAN/TILT
HOME
button
1.
Press the POSITION button so that the indicator lights up.
2.
Input the position number using the numeric keys (0 to 9).
The input figure is shown in the POSITION display to-
gether with a period after it.
(Example: When "48" is input)
To clear the input figure, press the CLEAR button.
3.
Press the ENTER button to enter the input position number.
The video of the selected position will be output from the
MONITOR OUTPUT connectors on the rear panel.
At this time, the period in the POSITION display disap-
pears.
NOTE
When a position number that has not been preset is
selected, the POSITION display shows the selected
position number but the video is not switched to that
position.
4.
To view the video of the next recorded position number,
press the + button. To view the video of the previous re-
corded position number, press the – button.
( REF. : Page 27 for the home position presetting.)
1.
Press the CAMERA button so that the indicator lights up.
2.
Press the HOME button. The CAMERA display shows "
and POSITION display shows "
CAMERA
3.
Press the ENTER button to move all the cameras into
their home positions.
When the cameras have moved to the home positions,
the CAMERA display shows the camera number that was
selected before the HOME button was pressed.
2. BASIC OPERATIONS
POSITION
Period
H0
".
POSITION
A
"
11