Connections; Basic System (A Mode); Connections Basic System (A Mode) - JVC RMP-2580U - Remote Controller For Color Domes Instructions Manual

4. CONNECTIONS

BASIC SYSTEM (A MODE)

This system accepts video signals from the cameras via the VIDEO INPUT connectors.
Up to 8 cameras can be connected in this system.
CAMERA 1
AC24V
ID:1
CAMERA 1
AC24V
ID:2
CAMERA 1
AC24V
ID:3
RM-P2580
Set Pin 1 to "OFF" for A Mode.
Camera 1 Camera 3
video video
Camera 2 Camera 4
video video
TO CAMERA
CAMERA
TO CAMERA TO CAMERA DATA I / O DATA I / O
RX RX+ RX RX- TX TX+ TX TX- COM COM 1 2 3 4 5 6 7 8 COM COM 9/1 9/1 10/2 10/2 11/3 11/3 12/4 12/4 13/5 13/5 14/6
POWER
OFF
ON
1 2 3 4
AC INPUT
1 2 3 4 5 6 7 8
1 2 3 4
ON ON
Camera 5 Camera 7
video video
Camera 6 Camera 8
video video
Setting Procedure
1.
Connect all the equipment.
(All the cameras must be synchronized).
2.
Set the system mode selection to A Mode, and set
the rear DIP SW1 to "OFF".
3.
To set a camera ( REF. : Instructions Manual of
the camera being used)
· Match the ID with the VIDEO INPUT number.
· Set to MULTIDOROP or DUPLEX
4.
Preset positions ( REF. : page 27)
5.
To change the setting values of the system in use
· CAMERA SELECTION: AUTO ( REF. : page 29)
· CAM SWITCH: LOW ( REF. : page 30)
6.
Operational setting values can be changed as re-
quired.
· P/T SPEED: 8 STEPS ( REF. : page 29)
· AUTO SEQUENCE SCREEN TIME: 2 SEC ( REF.
: page 32)
7.
Check the ALARM INPUT time set value.
· DATA I/O screen: 16ALM IN ( REF. : page 30)
· ALARM screen: ( REF. : page 32)
8.
ALARM INPUT TIME setting required for each cam-
era
·TERMINAL item ( REF. : page 31)
SW
COM
UNIT UNIT CAMERA CAMERA SERIAL-1 SERIAL-1 SERIAL-2 SERIAL-2
14/6 15/7 15/7 16/8 16/8 COM COM AUTO AUTO ALARM ALARM COM COM SW SW COM COM
VIDEO INPUT
5 6 7 8
MONITOR MONITOR MONITOR MONITOR
OUTPUT OUTPUT OUTPUT OUTPUT
1 2
5 6 7 8
VIDEO OUTPUT VIDEO OUTPUT
MONITOR
OUTPUT 1
REC
V.IN
MASTER MONITOR
MONITOR
OUTPUT 2
VIDEO CAM SW
IN OUT
REC
STOP REC EJECT OPERATE
CHECK
OPERATE
TIMELAPSE VCR
19