Setting Warmer Drawer Humidity Control; Setting Warmer Drawer Controls - Kenmore 9742 - 30 in. Electric Range Use And Care Manual

Setting Warmer Drawer Controls
• Warmer Drawer Humidity Controller (some models)
• Removing & Replacing Warmer Drawer (some models)
Warmer Drawer Humidity Controller Feature (some models)
This feature may be used to control humidity levels in the Warmer Drawer. The
control knob is located on the inner front panel of the Warmer Drawer.
To help keep foods moist, move the handle to the right. This closes the vents
and helps keep the moisture inside the Warmer Drawer. For crisp foods, move
the handle to the left. This opens the vents and allows more of the moisture to
escape.
For Moist Heat: Slide the humidity control knob in the direction of (More) _>
(See Fig. 1). This will help keep the food in the Warmer Drawer from drying out.
Both heat and moisture will be applied to the Warmer Drawer cavity.
For Dry Heat: Slide the humidity control knob in the direction of (Less) 4_ (See
Fig. 2). This allows more of the moist heat to escape and provides a dryer
environment for the food in the Warmer Drawer.
Fig. 1
Fig. 2
Note: For some types of servings you may want to store previously prepared food in a "dry heat" environment.
For frequent controller adjustments, slightly loosen humidity controller knob and slide to any desired position. To maintain
a desired setting, adjust controller knob into position and tighten knob.
Warmer (Warm & Ready
TM)
Drawer Indicator Light (some models)
The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays
on until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not
come on during the Self-Clean cycle.
30