Error Messages; Configuring Array Controllers; Configuring The Disk Drives - HP ML310 - ProLiant - G2 User Manual

Error messages

After the RILOE driver is installed, the following errors can occur:
In the Device Manager screen, two entries appear for the ATI Video Controller. One of these entries
has a yellow exclamation mark indicating that no driver is installed.
In the Event Viewer, the following message appears:
Unable to map address range for graphics card
These errors result from RILOE and the server using the same video controller. The operation of the server
is not affected by these error messages.
To disable one entry for the ATI Video Controller and prevent the error messages from occurring:
Right-click the Device Manager entry for the ATI Video Controller that has a yellow exclamation
1.
mark.
Select Disable.
2.
After the ATI Video Controller entry is disabled or when the server is rebooted, a red X appears in place
of the yellow exclamation mark. The red X indicates that the device is disabled. The disabled entry does
not affect the operation of the server.

Configuring array controllers

If an array controller has been purchased with the server, run the online ACU to set up the remaining
physical drives for use.
IMPORTANT:
to interface with the array controller. For the page to display properly, the server IP address
must be included in the trusted sites list. Internet Explorer must be restarted after adding the IP
address to the trusted sites list for the settings to take effect.
Click Start, and select All Programs>HP System Tools>HP Array Configuration Utility.
1.
Select whether you want to enable remote administration when prompted.
2.
Click OK.
3.
When prompted for the Web-Based Management password, enter the credentials for either the local
4.
administrator account or a local user account in the following format:
domain name\login name
Configure the remaining physical drives into logical drives, and run Disk Administrator to partition
5.
and format the additional drive space.
For more information about using the ACU, refer to the HP Online Help
(http://h18004.www1.hp.com/products/servers/proliantstorage/software-
management/acumatrix/index.html).

Configuring the disk drives

The primary logical drive, which contains the operating system, is the only drive on the server that is
configured during the operating system installation. Additional space that is not partitioned is also located
on the primary drive. This nonpartitioned space and any additional disk drives on the server must be
partitioned and formatted using Disk Administrator before they can be available for use.
Microsoft® Internet Explorer is required to run the ACU. Internet Explorer is used
Post-installation tasks 17