Toshiba 40E220U User Manual page 47

Setting upyourTV 47
Storing channels in memo O, (optional)
NOTE o:. Youmustset uptheANT/GABLE i nputsource before
programming channels.
•:. Theautomatic channel p rogramming process will erase
channels thatwerepreviouslyprogrammed i ntotheTV's
memory.
•:. TotunetheTVto a channel n otprogrammed in thechannel
memory, y oumustusetheChannel N umber b uttonson the
remote control.
•:. Programming c hannels whentheANT/CABLE i nput is
configured forcablewill takesubstantially longerthanwhenthe
antenna inputis configured for Antenna. T hisis normal;
however, oncechannel p rogramming is finished,youshouldnot
have to repeat t heprogramming process againunlessyourcable
TVservicelineupchanges significantly.
To program channels automatically:
1 Configure the antenna input source, if you have not already
done so, see "ANT/CABLE IN" on page 45.
2 Press the MENU button to open the Setup menu.
3 Highlight Installation, and then press the ENTER button.
(Sample Image) Setup menu - Installation selection
A new set of Installation menu icons appears.