Notice To Users - Oki CX4545 MFP Safety Information Manual

Notice to Users

After a suitable place has been selected for the installation of the ES9460 MFP/ES9470 MFP or CX3535 MFP/
CX4545 MFP, ES9160 MFP/ES9170 MFP, please do not change it. Avoid excessive heat, dust, vibration and direct
sunlight. Also, provide proper ventilation as the copier emits a small amount of ozone.
For the U.S.A. only
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
WARNING
Changes or modification made to this equipment, not expressly approved by Oki Data or parties authorized by Oki
Data, could void the user's authority to operate the equipment.
User Safety
This OKI Multifunctional Digital Systems does not produce laser radiation hazardous to the user. It is certified as a
Class 1 laser product under the U.S Department of Health and Human Services (DHHS) Radiation Performance
Standard according to the Radiation Control Health and Safety Act of 1968 including amendments.
Protective housing and external covers completely confine the laser beam light emitted inside the Multifunctional
Digital Systems. The laser beam cannot escape from the machine during any phase of user operation.
Regulations implemented on August 2, 1976 by the Bureau of Radiological Health (BRH) of the U.S Food and Drug
Administration apply to laser products manufactured from August 1,1976. Laser products marketed in the United
States must comply with these regulations.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
For the U.S.A. and Canada
Regulatory Information
Hg
 The high efficiency LCD backlights used in this product contains 5 mg or less of Mercury, the disposal of which
may be regulated due to environmental considerations. For disposal or recycling information, please contact
your local authorities or the Electronic Industries Alliance (www.eiae.org).
ES9460 MFP/ES9470 MFP/CX3535 MFP/CX4545 MFP
The unit is classified as Class 1 Laser Product according to IEC 60825-1:1993, IEC60825-1:2007 including
amendments.
The unit uses laser diodes with a max. output of 30 mW, a wavelength of 790 nm at a continuous pulse.
ES9160 MFP/ES9170 MFP
The unit is classified as Class 1 Laser Product according to IEC 60825-1:1993, IEC60825-1:2007 including
amendments.
The unit uses laser diodes with a max. output of 10 mW, a wavelength of 785 or 793 nm at a continuous pulse.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
Notice to Users 5