To Replace The Cooktop Neon Indicator Lights Pack; To Remove The Control Panel - AGA LEGACY 44 Service Instructions Manual

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

7. To replace the cooktop neon indicator lights pack

Lift up the ceramic hob see section 4.
The neon indicator light pack is held to the support bracket by two clips.
Either: -
Release the pack from the support by freeing the pack location clips from the bracket.
Or
Remove the mounting screws of the support bracket, and release the pack from the support
Disconnect the wiring , noting the colors and connection positions.
Fit the replacements pack and reassemble in reverse order.
Check that the replacement lights work.
bracket fi xing screws

8. To Remove the Control Panel

Turn off the power at the circuit breaker.
Pull off the push fi t control panel end caps at each end and
remove the end fi xing screws under the end cap.
Pull off all the control knobs. Open the broiler and
oven doors and remove the control panel fi xing screws
underneath the control panel. The screws directly below
the clock are for the clock fi xing bracket - don't remove
them at this stage.
Lift the control panel, pull forward and disconnect the
wiring from the rear.
Reassemble in reverse order. When replacing leads refer to
the wiring diagram. Check operation of timer.
SERVICING  WARNING
neon pack locaction clips
Remove the handrail by fi rst removing the 2 plastic
screw cover plugs and then the end bracket fi xing
screws beneath the plugs.
Remove the two screws that were hidden beneath the
hand rail end brackets.
16