AGA LEGACY 44 Service Instructions Manual page 6

Check 1
Open the oven door and turn on the oven light
Action
1 Are other parts of the range working - is the clock on, do the ovens and oven neons work? If not then there
is probably no power to the range. Investigate power supply.
2 Remove the light bulb (see 'Servicing Procedures'). Check the bulb with a resistance with a meter. The cold
resistance should be very approximately 100 ohms. Replace it if it is open circuit.
3 & 4 If the bulb is OK then move the range forward (see 'Servicing Procedures') and remove the rear cover. With
the meter check the continuity of the wiring to the bulb and the action of the switch. Replace wiring or
switch as necessary.
Check 2
Turn the function control to the
Defrost setting and check that the
oven fan starts to spin.
Remember - the clock must be set to
the time of day before the oven will
work.
Action 1
2
3 - 5
Check 3
Remove the oven racks. Turn the oven temperature
control to 400F and turn the function control to each
setting in turn and check that the elements start to heat
up. See the chart opposite.
You should be able to feel the heat from the element after
few moments by holding your hand close to the element
(DON'T TOUCH THE ELEMENTS!).
The bottom element may take slightly longer to heat up.
Turn the controls off when you have fi nished.
Action
One element not working
Remove the element - see the 'Servicing Procedures' section for the correct procedure.
Check it with a resistance meter. Replace with a new element if necessary. If the
element is OK then move the range forward (see the 'Servicing Procedures' section for
the correct method) and check the continuity of the wiring and the thermostat.
Checking the Multifunction Oven
Result
Fan does not spin
Are other parts of the range working - is the clock on, do the oven lights and oven neons work?
If not then there is probably no power to the range. Investigate power supply.
Remove the oven inner back and check that the fan is not impeded.
If the fan is not impeded, not then move the range forward (see the 'Servicing Procedures'
section for the correct method) and remove the rear covers. With a meter check the continuity
of the wiring to the fan and the action of the switch. Replace wiring, switch or fan as necessary.
Result
Light does not work
Possible Cause
Result
One element
does not heat up.
No element
heats up
6
Possible Cause
1 No power to range
2 Light bulb failed (most likely cause)
3 Fault in power supply to switch
4 Faulty switch
1 No power to range
2 Fan blades impeded
3 Fault in power supply to switch
4 Faulty switch
5 Fault in power supply to fan
6 Fan motor faulty
Possible Cause
Burnt out element (most likely cause)
Faulty switch
Fault in power supply to element
Faulty oven thermostat.(most likely cause)
Faulty switch
Fault in power supply to elements
No element working
Remove the range
cooktop and check the
thermostat and function
switch