Table of Contents
Advertisement
Manual
Page 26 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
7.2
Operating Mode 0 - Continuous Reading
When operating continuously the exciter is switched on permanently. The reading cycles
are initiated periodically.
After an accomplished reading cycle the reading information is evaluated. After that data (ei-
ther transponder number or NoRead code) is output to the serial interface
exciter
processor
reading cycle
interface
Figure 7.2: continuous operation
7.2.1 Settings of the Reader / Most Used Parameters
The default operation mode is changed by sending a software command to the reader.
In combination with an R / W transponder, the serial number of the transponder device is read
out only.
MD 0 -
most used parameters.
•
CID 0 -
•
CN 0 -
reading cycle
ID
ID
continuos read
no suppression of repeatedly read Ids
no suppression of NoReads
reading cycle
ID
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de
Hide quick links:
Advertisement
Table of Contents
