Table of Contents
Advertisement
Manual
Page 22 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
exciter
processor
reading cycle
interface
GT
Figure 7.1.2 : Software triggered reading operation with TOR>0
Please note: The TOR parameter is only active, if the GT-Command is applied. Within the
time span defined by the value of TOR no NoRead will be output on the interface!
7.1.1 Settings of the Reader / Most Used Parameters
The default operation mode is changed by sending a software command to the reader.
In combination with an R / W transponder, the serial number of the transponder device is read
out only.
MD 2 -
most used parameters.
•
CID 0 -
•
CN 0 -
•
NID 1
•
TOR XYZ
TOR 5
TOR
reading cycle
reading cycle
reading process
triggerd by an software command
no suppression of repeatedly read Ids
no suppression of NoReads
failure protection.; selection guide 2 out 2 transponder codes
maximum reading time after the standard read command
is applied to the reader. The chosen value must match the
timing demands of the production process.
Default value
NoRead
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de
Hide quick links:
Advertisement
Table of Contents
