Troubleshooting; Something Not Working - Electrolux ESL 63010 User Manual

27 electrolux something not working

Something not working

The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights,
which can be solved with the help of the indications described in the chart,
without calling out an engineer.
Open the door and carry out the following suggested corrective actions.
Fault code and malfunction
continuous flashing of the light of the
●
running programme,
intermittent audible signal,
●
1 flash of the end of programme
●
indicator light,
The dishwasher does not fill with water
continuous flashing of the light of the
●
running programme,
intermittent audible signal,
●
2 flashes of the end of programme
●
indicator light,
The dishwasher will not drain
continuous flashing of the light of the
●
running programme,
intermittent audible signals,
●
3 flashes of the end of programme
●
indicator light,
Anti-flood device is activated
Remember to switch off the appliance before carrying out any corrective action.
something not working electrolux 27
Possible cause and solution
The water tap is blocked or furred with
●
limescale.
Clean the water tap.
The water tap is turned off.
●
Turn the water tap on.
The filter (where present) in the threaded
●
hose fitting at the water inlet valve is
blocked.
Clean the filter in the threaded hose.
The water inlet hose has not been
●
correctly laid or it is bent or squashed.
Check the water drain hose connection.
The sink spigot is blocked.
●
Clean out the sink spigot.
The water drain hose has not been
●
correctly laid or it is bent or squashed.
Check the water drain hose connection.
Close the water tap and contact your
●
local Service Force Centre.