Toro 20330 - Low Wheel Walk Power Mower Service Manual page 127

2. Install the tool over the stop in the handle guides as
shown, one on each side. Push the handle down.
The tool will allow the handle to slide over the stop
built into the handle guide (Fig. 239).
3. As the handle begins to slide downward, pull the
traction control bar farther out of the handle (Fig.
240).
A
A. Traction Control Bar
WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
Fig 239 MVC-005a
Fig 240 MVC-707a
4. Continue pushing the handle down until it slides off
the end of the upper handle (Fig. 241).
5. When reinstalling the handle, reconnect the spring
as shown. The spring should push the handle
upwards toward the disengage position (Fig. 242).
Fig 241 MVC-709a
Fig 242 MVC-710
7-7