Adjusting The Personal Pace Cable; Handle Removal; Personal Pace Generation 2/Easy Stride Generation 2 - Toro 20330 - Low Wheel Walk Power Mower Service Manual

HANDLES AND CONTROL CABLES

Adjusting the Personal Pace Cable

Ensure the transmission belt is disengaged, transmission
tilted forward. Loosen the cable clamp on the handle.
When you pull the cable down the personal place handle
should raise to the stop. Hold the cable and secure the
clamp (Fig. 236).
Personal Pace Generation 2/Easy Stride
Generation 2
7-6
Fig 236 DSC-4829a
Fig 237 20018_handle
This is the second generation of the personal pace/
easy stride handle assembly. It works the same as the
original in the sense that the handle is telescoping. As
the handle is depressed it tightens the self propelled belt
and drives the transmission.

Handle Removal

To ease removal of the Personal Pace handle from a 22"
Recycler, make a tool from a piece of metal strapping
or banding material. You will need two pieces about 5"
(12.7cm) long each. Bend them as shown in the photo
and round the ends to remove burrs. This tool permits
the handle to slide up and over the internal handle stops
(Fig. 238).
1. Disconnect the control cables and the key switch
(electric start models) from the upper handle and
Personal Pace handle. Separate the upper and
lower handle. Remove the brake bail by pressing the
two ends together until they come out of the holes in
the handle.
Fig 238 MVC-712
WPM Drive Systems Manual