13. Removing the PAD PCB
1. Disconnect the connectors CN3005 and CN3006.
2. Unhook the four hooks of the Top Cabinet and
remove the PAD PCB.
14. Removing the Touch Pad
1. Unhook the four hooks of the Top Cabinet and
remove the Touch Pad.
15. Removing the Batt / Audio
PCB
1. Disconnect the connector CN1 from the Battery /
Audio Card Cable.
2. Remove the four screws <L> and remove the Batt /
Audio PCB.
Screw <L> : DXHM0009WB
16. Removing the Antenna PCB
(L), (R)
1. Disconnect the connector of the Wireless LAN
Module and peel off the tape, and then remove the
Antenna Cable (L), (R).
2. Remove the screw (M) from the Antenna PCB (L)
and remove the screw (M) from the Antenna PBC
(R).
Screw <M> : DXSB2+5FZLT
14-6