Panasonic CF-29CRKGZKM - Toughbook 29 - Pentium M 1.2 GHz Service Manual page 36

7.2.6. Setting the Handle and Power SW
1. Set the Power SW.
2. Set the Handle.
3. Fix the Handle Base Land R using the two Screws<g>.
Screws <g>: DRSB4+8FKL
7.2.7. Setting the Palm Top Cover Sheet, Palm Top Cover, Touch Pad Adhesion Seat,
Touch Pad, Touch Pad SW Knob, LED PCB and SW LED PCB
1. Set the SW LED PCB.
2. Attach the Power LED Packing Sheet to the LED Spacer
Sheet.
3. Attach the LEDX6 Spacer Sheet on the SW LED PCB.
4. Fix the SW LED PCB using the Screw<f>.
5. Attach the PW LED Sheet.
6. Pass the Cable of LED PCB through the hole 1 on the
Top Cabinet, then set the LED PCB.
7. Attach the LED Spacer Sheet on the LED PCB
8. Set the Touch Pad SW Knob In and Touch Pad SW Knob.
9. Attach the TP Bottom Tape to the Touch Pad.
10. Pass the Cables of the Touch Pad through the hole 2 on
the Top Cabinet, set the Touch Pad.
11. Attach the Touch Pad Adhesion Seat.
12. Fix the Palm Top Cover using the five Screws<e>. No1 to
No5
13. Attach the Palm Top Cover Sheet.
Note:
Tighten the Screws in the numbered order (No1 to No5).
Screws <e>: DRHM0002ZA
Screw <f>: DRHM0002ZA
<g>
Handle Base L
Power
SW
<e>
:No2
<e>
:No1
<e>
<e>
:No5
:No4
Touch Pad
SW Knob
LEDX6
Spacer
Sheet
LED PCB
Cable
FCC CN
Stopper
Hole 1
Hole 2
7-18
<g>
Handle
Handle Base R
Palm Top Cover Sheet
<e>
:No3
Palm Top Cover
PW LED Sheet
Touch Pad <f>
LED Spacer
Adhesion Seat
Sheet
Power LED
Packing Sheet
Touch Pad
SW LED PCB
Cable
TP Bottom
Tape
Tape CPU
Power SW
PCB Cushion
Touch Pad
SW Knob In
Top Cabinet