Buttons; Port Status; Accessing The Interface Without Using Discovery - 3Com 3C16476BS-US - Baseline 2250 Plus Switch User Manual

24 C 3: C
HAPTER ONNECTING TO THE
Menu Item
Port Configuration
VLANs
Trunking
Traffic Monitoring
System Tools
Support
Log Out

Buttons

Depending on the screen that is currently displayed,
the following buttons may appear:
Apply – Click to save and apply any changes that
■
you have made
Cancel – Click to discard any unsaved changes
■
W I
EB NTERFACE
Description
Allows you to configure the Switch's
port settings
Allows you to create VLAN groups,
add port members, and specify how
VLAN tagging is used
Allows you to set up and maintain
trunk membership for port groups
Allows you to perform port traffic
monitoring on the Switch. To monitor
a port, you will also need a network
analyzer.
Contains tabs that allow you to:
Restart and reset the Switch
■
Back up and restore configuratio
■
Upgrade the firmware
■
Configure forwarding of BPDU
■
packets to support a spanning tree
topology
Enable and disable 802.1p prioriti-
■
zation
Displays 3Com contact information
and describes how to use the online
help system
Allows you to securely log off the
Web interface
Help – Click to display the context-sensitive help
■
information for the screen that is currently dis-
played. The help pages provide information on the
tasks that you can perform on each screen.

Port Status

At the bottom of each screen is an image of the
Switch's front panel, which indicates ports that are
currently in use.
To configure a port, click the port on the image. This
takes you to the Basic Port Configuration tab, where
you can:
Assign a name (or label) to the port
■
Enable or disable the port
■
Enable or disable flow control
■
Configure the speed duplex settings
■
Accessing the Interface Without Using
Discovery
The Discovery application works by automatically
detecting the IP address that is assigned to the
Switch, and then using that address to connect to the
Web interface. If you know the Switch's IP address,
you can access the Web interface without using Dis-
covery.
This section describes how to access the interface
directly, without using Discovery.