2.5.2 Entering N2KServer
Once the MBB100 has been properly configured to connect to your LAN, you must configure the
connection to enable the MBB100 to receive information from an instance of N2KServer
IPG100 Server. This is done through the following steps:
a.
Click anywhere inside the N2KView
above.
b.
Click on the "Connections" tab on the right side of the N2KView
Connections Settings dialog.
Revision 1.0
®
or IPG100 Connection Information
Figure 12 – N2KView
®
®
Window with Tabs Displayed
screen to display the screen tabs as shown in Figure 12
®
or an
®
screen to display the
® ®
Page 11