Nmea 2000; Connection; Figure 6 - Fluid Flow Sensor Connection Diagram - Maretron FFM100 User Manual

FFM100 User's Manual
Pin # Signal Name
1 P0
2 G0
3 A0
4 B0
5 C0
6 T0
7 P1
8 G1
9 A1
10 B1
11 C1
12 T1
Please refer to Figure 6 for connecting the FFM100 to a M1RSP-2R-E8, M2RSP-2R-E8, or
M4ARP-2-E8 fluid flow sensor. This figure shows the connection of the fluid flow sensor to
channel 0. Connections to other channels are similar.
1 2 3 4 5

2.5.2 NMEA 2000

®
The NMEA 2000 connector can be found on the side of the enclosure. The NMEA 2000
connector is a round five pin male connector (see Figure 7). You connect the FFM100 to an
®
NMEA 2000 network using a Maretron NMEA 2000
cable) by connecting the female end of the cable to the FFM100 (note the key on the male
connector and keyway on the female connector). Be sure the cable is connected securely and
that the collar on the cable connector is tightened firmly. Connect the other end of the cable
(male) to the NMEA 2000
you can plug or unplug it from an NMEA 2000
Page 10
Fluid flow sensor 0 power connection
Fluid flow sensor 0 ground connection
Fluid flow sensor 0 phase A connection
Fluid flow sensor 0 phase B connection
Fluid flow sensor 0 phase C connection
Fluid flow sensor 0 temperature sensor connection
Fluid flow sensor 1 power connection
Fluid flow sensor 1 ground connection
Fluid flow sensor 1 phase A connection
Fluid flow sensor 1 phase B connection
Fluid flow sensor 1 phase C connection
Fluid flow sensor 1 temperature sensor connection
Table 1 - Fluid Flow Sensor Connections
6 7 8 9 10 11 12
Figure 6 – Fluid flow sensor Connection Diagram
®

Connection

®
network in the same manner. The FFM100 is designed such that
Connection
FFM100 Screw Terminals
®
cable (or an NMEA 2000
®
network while the power to the network is
Fluid flow sensor
®
compatible
Revision 1.2
®