Table of Contents
Advertisement
If no data is displayed, please check the following:
1.
Make sure the "Server Password" entered in N2KView
entered into the N2KServer
IPG100, as appropriate. If the server is running on an IPG100, the password in the IPG100 is
set from a DSM250 or N2KAnalyzer
2.
Make sure the "Server Address" matches the IP address of the computer or IPG100 running
®
N2KServer
.
3.
Make sure you have appropriate instruments on the NMEA 2000
you are trying to view on the N2KView
®
N2KView
and the N2KServer
4.
Make sure that the instances that are being monitored correspond to the instances being
transmitted. You can set the instance number of the component to "Any" to make sure that
there is any data of that type on the bus.
Revision 1.0
®
Service Manager on the computer running N2KServer
®
.
®
screen. (To test the network connection between
®
, you may wish to run N2KServer
®
matches the "Server Password"
®
network to provide the data
®
in "Simulated Data" mode).
® ®
®
, or the
Page 13
Advertisement
Table of Contents
