Manually Entering Lan Connection Information; Figure 10 - N2Kview Window With Tabs Displayed - Maretron MBB100 User Manual

Alternatively, you may Enter Demo Mode. In Demo Mode, you will not be able to connect to a Server
and view live data; instead simulated data will be provided to stimulate the controls.
The first time you start the MBB100, you must ensure that the device can connect to your LAN (local
area network). The MBB100 comes from the factory preconfigured to obtain its LAN connection
information from a DHCP (Dynamic Host Control Protocol) server. If your local area network uses a
DHCP server, no configuration is necessary, and the MBB100 should be able to successfully connect
to the local area network.

2.5.1 Manually Entering LAN Connection Information

If your local area network does not use DHCP, you must manually enter the LAN connection
information into the MBB100. This is done through the following steps:
a. Click anywhere inside the N2KView
above.
b. Click on the "Configuration" tab on the right side of the N2KView
Configuration dialog.
Revision 1.0
Figure 10 – N2KView
®
®
Window with Tabs Displayed
screen to display the screen tabs as shown in Figure 10
®
screen to display the
® ®
Page 9