Magnavox ZV450MW8 - DVD Recorder And VCR Combo Owner's Manual page 39

Checking, canceling, or correcting the timer
programming information
1) Press [TIMER SET].
2) Press [TIMER].
3) Check the information on the list you will need.
Timer Programming
Date Start
1. JAN/01 12:57AM 1:57PM
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
4) To clear the timer programming:
Use [K / L] to select the program, then press
[CLEAR].
To correct the timer programming:
Use [K / L] to select your desired program, then
press [OK].
Next, correct the timer programming by using
[K / L / { / B]. Finally, press [OK] again.
5) Press [TIMER] to exit.
6) Press [TIMER SET] to return to the timer standby
mode.
To stop the timer recording in process
Press [STOP C] to stop the disc recording or
[STOP C/EJECT A] to stop the cassette tape recording
on the front panel of the unit.
[STOP C] on the remote control is not effective.
Note
• Press [TIMER] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case,
you cannot select any other program.
TIMER RECORDING
VCR DVD
DVD
End CH Mode
VCR
8 DVD HQ
If the timer program did not complete correctly,
the error number appears in the timer pro-
gramming list.
Timer Programming
Date Start
* JAN/01 12:57AM 1:57PM
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
Press [CLEAR] to erase the selected program.
Each error number means:
E1-22 Recording error other
E37-39 than below
E24 Unrecordable disc
E25-26 Copy prohibited
program
E29 Disc protected
E30 Disc full
E35 PCA full
E36 Already finalized
video format disc
E40 Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
• E23, E27, E28, E31, E32, E33 and E34 are not displayed.
• A program with the error number is grayed and
asterisked in the timer programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
VCR DVD
DVD
End CH Mode
VCR
8 DVD E22
E41 Power failed
E42 No disc when
recording
E43 Already 49 titles
recorded
E44 Already 254 chapters
recorded
E45 Copy prohibited
program
E46 It is impossible to
record additionally
on a disc recorded
by other units when
setting "Replace Disc
Menu" to "OFF".
EN EN 39 39