Magnavox ZV450MW8 - DVD Recorder And VCR Combo Owner's Manual page 83

Playback (cont'd)
1
Disc Audio (Default: Digital Out)
Choose the appropriate audio setting for your external
device.
It will only affect a disc playback.
Use [K / L] to select a desired item, then press [OK].
Disc Audio
Digital Out
Dynamic Range Control
Digital Out
Set the digital audio output.
Use [K / L] to select a setting, then press [OK].
Digital Out
PCM
Dolby Digital
Selection menu will appear. Proceed to step A or B .
A
Settings for PCM (Default : 48kHz)
Use [K / L] to select a setting, then press [OK].
Digital Out - PCM
48kHz
96kHz
Your setting will be activated.
48kHz : If your amplifier/decoder is NOT compatible
with 96kHz PCM, select "48kHz". 96kHz sound
will be output in 48kHz.
96kHz : If your amplifier/decoder is compatible with
96kHz PCM, select "96kHz". 96kHz sound will
be output.
Note
When playing back disc with copyright protection
• Even if you select "96kHz", the sound will be down
sampled at 48kHz.
B
Settings for Dolby Digital (Default : Stream)
Use [K / L] to select a setting, then press [OK].
Digital Out - Dolby Digital
PCM
Stream
Your setting will be activated.
PCM : Converts the Dolby Digital into PCM (2 channel).
When your amplifier/decoder is NOT
compatible with Dolby Digital, set to "PCM".
Stream : Outputs Dolby Digital signals
When your amplifier/decoder is compatible
with Dolby Digital, set to "Stream".
SETUPS
DVD
ON
DVD
48kHz
Stream
DVD
DVD
Dynamic Range Control (Default : ON)
Set to "ON" to compress the range between soft and loud
sounds.
Use [K / L] to select a setting, then press [OK].
Dynamic Range Control
ON
OFF
Your setting will be activated.
Note
• Dynamic range control function is available only on
the discs which are recorded in the Dolby Digital
format.
2
Video (Default: Progressive Scan)
Use [K / L] to select a desired item, then press [OK].
Video
Progressive Scan
Still Mode
Progressive Scan (Default : OFF)
This unit is compatible with the progressive scan system.
The feature provides you with the higher definition
images than the traditional output system does. To utilize
this feature, you must set progressive scan mode to "ON".
1) Use [K / L] to select "ON", then press [OK].
Video - Progressive Scan
ON
OFF
2) Use [{ / B] to select "Yes", then press [OK].
Video - Progressive Scan
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.
NOTE:
If there is no picture or picture is
distorted after selecting "Yes",
Wait about 15 seconds for auto recovery.
Activate?
3) Use [K / L] to select "Yes" within 15 seconds, then
press [OK].
Your setting will be activated.
Note
• If your TV is compatible with progressive scan (525p /
480p), you are recommended to use the component
video cable (commercially available) to connect this
unit to the TV. (Refer to "Method 2" on page 16.) If
not, use the RCA video cable and set the progressive
scan to "OFF" or press and hold [SETUP] for more
than 3 seconds during DVD playback.
• When selecting "No" or not pressing any buttons on
the unit or remote control within 15 seconds at step 3,
progressive scan remains to be "OFF" (interlace scan).
DVD
DVD
OFF
Auto
DVD
DVD
Yes
No
EN EN 83 83