HP Kayak XW A2-U2-W2 Manual page 14

Host SCSI ID
Scan Order
Removable Media
Support
CHS Mapping
HP Kayak XW 0480 PC Workstation — Configuring a SCSI Accessory
In general it is not advisable to change your host adapter ID from the
default value of 7, as this gives it the highest priority on the SCSI bus.
However, if you have two adapters sharing the same SCSI devices, you
should give one of the adapters a currently-unassigned ID to avoid
duplication of SCSI IDs.
This option lets you tell the host adapter BIOS and your device drivers
to scan the SCSI bus from low to high (0 to max) SCSI ID, or from high
to low (max to 0) SCSI ID. If you have more than one device on a SCSI
bus, changing the device order changes the drive letters which are
assigned to them by the system. This will change the boot order.
Only used when removable disk drives are installed. For more
information, refer to the User's Guide that came with you removable
disk drive.
When performing a 'low format', CHS mapping should be set to
Alternate CHS Mapping
adapters. This is the default setting.
14 English
for full compatibility with other SCSI