HP Kayak XW A2-U2-W2 Manual page 17

Disconnect
Read Write I/O Timeout
(sec)
Scan for Device at Boot
Time
Scan for SCSI LUNS
Queue Tags
Format Disk
Verify Disk Media
This option lets you enable or disable disconnects for the device.
To optimize SCSI bus performance, this option should be set to
Enabled when two or more SCSI devices are connected to the host
adapter. Set the option to Disable to achieve slightly better
performance when only one SCSI device is connected to the SCSI bus.
This option lets you enter a read write timeout value in seconds for the
device.
This option lets you specify whether the device is scanned for at boot
time. The choices are Yes or No.
More advanced SCSI devices can have several logical units (LUNs). This
option lets you specify whether SCSI LUNs are scanned for at boot time.
The choices are Yes or No.
This option lets you specify whether queue tags are enabled or disabled.
In a multi-tasking environment this option must be enabled. It should
only be disabled for troubleshooting.
This utility can be used to perform a low-level format of a hard disk.
Most SCSI disks are pre-formatted and do not need low-level formatting.
This utility scans for media defects on the selected SCSI device. Press
the key to abort this utility.
Exiting from the Configuration Utility
To exit from the Configuration utility, press
of times to return to the Main menu, and then press
HP Kayak XW 0480 PC Workstation — Configuring a SCSI Accessory
the necessary number
to quit.
English 17