Table of Contents
Advertisement
To prevent data loss, set this parameter to Auto if you are using a hard disk
with more than 528 MB capacity that was previously configured through the
LBA mode. If you use a hard disk configured through the user-specific cylinder-
head-sector (CHS) mode, set this parameter to Disabled.
Hard Disk 32-bit Access Setting this parameter to Enabled improves system
performance by allowing the use of the 32-bit hard disk access. This enhanced
IDE feature only works under Windows 3.x, OS/2, Windows 95, Windows 98,
and Novell NetWare. If your software does not support this function, set this
parameter to Disabled. The default setting is Enabled.
Input/Output Ports
From the Setup main menu, select the Input/Output Ports option to view or
change port configuration settings. The Input/Output Ports menu appears.
This menu lets you configure serial and parallel ports.
Also included in this menu are items for enabling or disabling the onboard
controller chipsets.
Serial Port
Your computer comes with a 9-pin serial port. This parameter displays the
current address for serial port. The default setting Base Address is 2F8 and the
default IRQ is 3.
Parallel Port
Your computer comes with one parallel port. This parameter shows the default
Enabled to activate the parallel port. The default base address is 378h and the
default IRQ is 7.
The default mode is ECP. The default DMA is 3.
Onboard PS/2 Mouse (IRQ12)
This parameter enables or disables the onboard PS/2 mouse. When set to
Enabled, it allows you to use the onboard PS/2 mouse. When set to Disabled,
it deactivates the mouse and frees IRQ 12 for the use of other devices (for
2163).
Onboard USB
This parameter allows you to enable or disable the Universal Serial Bus (USB)
controller. The default setting is Enabled.
USB Legacy Mode This parameter enables or disables the use of a USB
keyboard outside of Windows. The default is Disabled.
16
Hide quick links:
Advertisement
Table of Contents
