Installing Brightmail Control Center; Hardware Requirements - Symantec BRIGHTMAIL - SYM ANTISPAM AND Installation Manual

Installing Brightmail Control Center

The Brightmail Control Center is a Web-based cross-platform configuration and
administration center built in Java. Each Symantec Brightmail AntiSpam installation has
one Brightmail Control Center, which also houses Brightmail Quarantine and supporting
software. You can configure and monitor all of your Brightmail Scanners from the Control
Center. This section describes the environment needed to install a Brightmail Control
Center, and gives a step-by-step guide for installation.
The following major sections are included:

Hardware Requirements

•
Software Environment Requirements
•
Upgrading Software
•
Installing Brightmail Control Center on UNIX
•
Installing Brightmail Control Center on Windows
•
Automatic Startup Configured by Brightmail Control Center Installer
•
Uninstalling Brightmail Control Center on UNIX
•
Uninstalling Brightmail Control Center on Windows
•
If you are upgrading from Version 6.0.0 or 6.0.1, refer to
NOTE:
on page
Hardware Requirements
The Brightmail Control Center requires the following minimum hardware setup:
• Solaris
— UltraSPARC processor
— 512 MB RAM minimum (1 GB or more recommended)
— 250 MB disk space minimum (1 GB or more recommended)
• Linux or Windows
— Intel Pentium or compatible III or IV processor
— 512 MB RAM minimum (1 GB or more recommended)
— 250 MB disk space minimum (1 GB or more recommended)
60.
Installation Guide
"Upgrading Software,"
57