3Com Router 3016 Installation Manual page 48

48 C 5: M
HAPTER AINTAINING THE
R
OUTER
As you configure these parameters, set the values so that:
The IP address of the TFTP server is the IP address of the PC connected to the
■
Ethernet port on the router.
The IP address and subnet mask are the same as the IP address and subnet
■
mask of the LAN0 port.
The IP addresses of the PC network interface and the LAN0 port of the
■
router reside on the same segment.
After you enter the last parameter, the following information displays and you can
verify that the parameters are set correctly.
----------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 10.110.10.10
LAN interface's subnet mask is 0xffff0000
HARDWARE PARAMETERS:
Processor type is MPC8241
Internal Clock Rate 200 Mhz
External Clock Rate 100 Mhz
Serial channels will use a baud rate of 9600
TFTP SERVER PARAMETERS:
IP address of the TFTP host is 10.110.10.13
The file to download and start is m8241ram.arj
After board is reset, start-up code will wait 5 seconds
---------------------------------------------------------------
(M)odify any of this or (C)ontinue? [M]C
5 Enter C to confirm this configuration or M to modify any of the parameter
settings.
To enter the Boot menu:
1 Boot the system normally.
2 Press Ctrl+B within 5 seconds of the prompt that tells you to do so.
3 Enter the BootROM password, if necessary.
4 Enter 2 at the Boot menu, and select to download the application program
through TFTP. The following information displayS:
Please start TFTP server then press ENTER key to get started
5 If the PC running TFTP Server is ready, press Enter to begin loading the program.
Starting the TFTP download...
..................................................................
TFTP download completed...
read len=[03713478]
Writing program code to FLASH...
Please waiting,it needs a long time (about 5 min)
##############################
Write Flash Success.
Press ENTER key to reboot the system.
6 After the loading, press <Enter> to reboot the router.