Workbench Requirements - 3Com Router 3016 Installation Manual

22 C 2: P
HAPTER REPARING TO
Workbench
Requirements
Inspecting the Router
and Accessories
Installation Equipment
I R
NSTALL THE OUTER
Whether you install the router in a cabinet or directly place it on the workbench, it
is necessary to ensure that:
There is spacing reserved at the air inlet and outlet in the router so as to
■
facilitate the ventilation of the router cabinet.
The cabinet and workbench are firm enough to support the weight of the
■
router and other installation accessories.
The cabinet and workbench are well grounded.
■
After you verify that the installation conditions comply with these requirements,
open the packing case of the router and check the contents against the your order
contract. Contact your Service representative if you find any discrepancies.
To install your router, you will need:
Tools
■
Phillips screwdriver
Flat-head screwdriver
ESD-preventive wrist strap and ESD-preventive gloves
Flat-blade screws (used in wall mounting)
Cables
■
Ethernet cable
Console cable
AUX cable
Power supply, power cord, and chassis ground wire
Interface cables for the selected interface modules
Equipment
■
A router
Ethernet 10/100Base-T Hub or LAN switch
Channel service unit/data service unit (CSU/DSU) or other data communications
equipment (DCE) equipment (such as a modem)
Configuration terminal, such as a PC
Additional equipment for the selected interface modules