Table of Contents
Advertisement
Page 18 of 29
Recording on the HS-P82
To begin recording, depress the physical button on the right of the display marked RECORD. To end
recording, press STOP.
To record the next take, just press RECORD again. The take number automatically increments.
To playback a take, just press PLAY. To go back to a prior take, or advance to a later take, just press the
<< BACK or FORWARD>> buttons.
If you need to search for a very distant take, either press the scene/take label box just above the
meters, or the PROJECT button. Both will take you to the Project screen, where you will see an index of
scenes & takes. Pressing the ENTER arrow button adjacent to the desired take will "load" that take into
the current location. Then just use the PLAY keys.
When it is time to roll sound for a new take, just press RECORD. The take number will automatically
increment to the correct number, regardless of the fact that you just played back an early take of that
same scene.
If you loaded a different scene to play back than the current one, when you press RECORD it will
increment to a new take number of the (just loaded) scene. So in that case, you would want to return to
the correct scene before going into RECORD. Go back to the index, and select any take from the scene
that you need to be in. Press enter to load it. Now you are ready to record the next take.
Head tone and header ID
Before recording any actual film takes, you should always record a header file. That file should consist of
the soundmixer reading the basic production information into the slate mic.
Advertisement
Table of Contents
