Table of Contents
Advertisement
Page 11 of 29
Start with the Setup tab.
You can assign a name to any track for your convenience. For example, you could rename
Track 1 as "Boom"
Channel Link is for linking a stereo microphone so that one set of controls spans over two input
channels. MS Mic mode is for when you are recording unprocessed mid-side tracks with an M-S
type mic.
The TRIM GROUP tab allows you to link the gain level of any input so that one track controller knob is
master over the group. For most film/video production, you would not use this feature.
The INPUT tab lets you select analog or digital input for each channel. If you are bringing in digital
sources, the Fs CONVERT button allows you to turn on a sampling rate converter. You can also activate
PHANTOM mic powering for each input.
The SIGNAL PROCESSING tab allows you to reverse the acoustic phase of a given channel, to engage a
low cut filter, or to engage a limiter. You can dial in the variables for the low cut settings for each
channel by pressing the main LowCut Filter button on the left of the screen.
Advertisement
Table of Contents
