Replicating The Setup - HP Dx5150 - Compaq Business Desktop Management Manual

Business desktops

Hide thumbs Also See for Dx5150 - Compaq Business Desktop:

Table of Contents

Desktop Management Guide

Replicating the Setup

To recover the system after it enters Boot Block recovery mode,

complete the following steps:

1. If there is a diskette in the diskette drive or a CD in the CD drive,

remove the diskette and CD and turn off the power.

2. Insert a ROMPaq diskette into the diskette drive or, if permitted

on this computer, a ROMPaq CD into the CD drive.

3. Turn on the computer.

If no ROMPaq diskette or ROMPaq CD is found, you will be

prompted to insert one and restart the computer.

If a supervisor password has been established, the Caps Lock

light will turn on and you will be prompted to enter the password.

4. Enter the supervisor password.

If the system successfully starts from the diskette or CD and

successfully reprograms the ROM, a rising tone series of beeps

signals successful completion.

5. Remove the diskette or CD and turn the power off.

6. Turn the power on again to restart the computer.

To replicate or copy one setup configuration to other computers of the

same model, HP has provided a Windows-based software utility,

System Software Manager, that can be downloaded from

http://www.hp.com/go/ssm

Save/Load utility, that can be downloaded from

http://www.hp.com/support/files

Support Web site, enter the name of your computer when prompted.

www.hp.com

, plus a DOS-based software, CMOS

. After logging on to the HP

Desktop Management Guide

Table of Contents

Dx5150 series