Storage Controller Option - HP DL120 - ProLiant - G5 User Manual

Install the optional PCI-X riser board.
8.
Install the expansion board
9.
IMPORTANT:
properly.
Install the PCI riser board assembly (on page 8).
10.
Connect any internal cables for expansion boards.
11.
Install the primary access panel.
12.
Install the server into the rack.
13.

Storage controller option

IMPORTANT:
documentation that ships with the option.
To install the component:
Power down the server (on page 6).
1.
Remove the server from the rack (on page 6).
2.
Remove the primary access panel (on page 7).
3.
Remove the secondary access panel (on page 7).
4.
Remove the PCI riser board assembly (on page 7).
5.
Remove the hard drive cables.
6.
Install the storage controller
7.
Connect the storage controller cable to the controller and to the hard drive.
8.
See the server installation sheet and the documentation that ships with the storage controller.
IMPORTANT:
properly.
("Expansion board
The server does not power up if the PCI riser board assembly is not seated
For additional installation and configuration information, refer to the
("Expansion board
The server does not power up if the PCI riser board assembly is not seated
option" on page 24).
option" on page 24).
Hardware options installation 27