HP dc72 - Blade Workstation Client Setup And Configuration Manual page 27

Q: Who provides Setup and Configuration Servers?
A: Openview and ISVs such as Altiris provide Setup and Configuration Servers. Check with your
management console supplier to see if they offer this service.
Q: Can AMT be set for static address and the OS set for DHCP or vice versa?
A: No. Although it can be done, this is not a supported setting by Intel and may cause unexpected
system behavior.
Q: What is the default port used by the Intel WebGUI?
A: The Intel WebGUI listens to port 16992.
Q: What is the difference between the ME and AMT?
A: The ME is the controller that manages AMT along with ASF and QST. Notice that clearing AMT
settings does not affect ME settings since the ME is a separate entity.
Q: Why did my AMT setting get cleared when upgrading from AMT 2.0 to AMT 2.1?
A: Upgrading from AMT 2.0 to AMT 2.1 requires an update to the ME firmware, which will clear AMT
settings. The system needs to be set up and configured again.
Q: Why does Wake-On-ME not work after the Idle Timeout is set?
The Wake-On-ME feature only works if the ME On in Host Sleep State setting is set to Always
A:
and the system is fully provisioned.
Q: Why does Wake-On-ME not work after CMOS is cleared?
A: If CMOS is cleared, then the default Idle Timeout value will be zero. Change to a non-zero value to
re-enable Wake-On-ME.
Q: Why does going from AMT 2.0 to AMT 2.1 by updating the BIOS and ME firmware not
automatically enable Wake-On-ME?
A: Updating the ME firmware does not affect the preset system options set previously by an administrator
or the factory. Wake-On-ME is a new feature for AMT 2.1 so the Idle Timeout field is set to zero in
AMT 2.0 systems.
27