HP dc72 - Blade Workstation Client Setup And Configuration Manual page 10

Select Intel AMT Configuration.
14.
Figure 5 Intel AMT Configuration screen
15. Select Host Name, and then type a host name.
Default Setting = IntelAMT, Recommended Setting = User Dependent
NOTES: Spaces are not accepted in the host name. Make sure there is not a duplicate host name on the
network. You can use host names in place of the system's IP for any applications requiring the IP address.
Select TCP/IP.
16.
a. Select Disable Network Interface, and then select N.
Default Setting = Network Interface Enabled, Recommended Setting = Network Interface
Enabled
If the network is disabled, then all remote AMT capabilities are disabled and TCP/IP settings are
not necessary.
This option is a toggle, and the next time you access it you are prompted with the opposite
setting.
b. Select DHCP Disable, and then select Y.
Default Setting = DHCP Enabled, Recommended Setting = User Dependent
You can use DHCP if it is available. If you use DHCP, then steps 16c through 16g are not
necessary. Otherwise, the system administrator will have to configure TCP/IP settings.
For the purpose of this white paper, DHCP is disabled so steps 16c through 16g can be
illustrated. Step h will appear for both DHCP and Static configurations.
10