Usb Drive Key Requirements - HP dc72 - Blade Workstation Client Setup And Configuration Manual

7. The system BIOS displays a message that automatic setup and configuration will occur.
a. The first available record in the Setup.bin is read into memory. The process:
i. Validates the file header record.
ii. Locates the next available record.
iii. Invalidates current record so it cannot be used again.
b. The process places the memory address into the MEBx parameter block.
c. The process calls MEBx.
8. MEBx processes the record.
9. MEBx writes a completion message to display.
10. The IT technician powers down the system. The system is now in In-Setup phase and is ready to be dis-
tributed to users in an Enterprise mode environment.
11. Repeat Step 5 if necessary (more than one system).
Refer to your management console supplier for more information on USB drive key set up and configura-
tion.

USB Drive Key Requirements

The USB drive key must meet the following requirements to be usable in USB Drive Key Setup and Config-
uration:
•
It must be greater than 16MB.
•
The sector size must be 1KB.
•
The USB drive key is not formatted to boot.
•
The Setup.bin file must be the first file landed on the USB drive key.
25