HP StorageWorks 4000s - NAS Installation Manual page 36

Use Table 3
be powered on during each step.
Table 3: Power Sequencing for Cluster Installation
Step
Setting up
networks
Setting up
shared disks
Verifying Disk
Configuration
Configuring
the First Node
Configuring
the Second
Node
Post-installation
36
DRAFT
to determine which nodes and storage devices should
Node Additional
1 Nodes
On On
On Off
Off On
On Off
On On
On On
HP Restricted
Storage
Not
Presented
Presented
Presented
Presented
Presented
Presented
NAS 4000s and 9000s Installation Guide
Comments
Verify that all
storage devices on
the shared bus are
not presented. Power
on all nodes.
Shutdown all nodes.
Present the shared
storage, then power
on the first node.
Shut down first
node, power on the
next node. This
process will need to
be repeated for all
cluster nodes.
Shutdown all nodes;
power on the first
node.
Power on the next
node after the first
node has been
successfully
configured. This
process will need to
be completed for all
cluster nodes.
At this point all
cluster nodes should
be on.