10-6.Adjusting the thread take-up amount
At the time of shipment from the factory, the thread take-up amount (stroke) of the thread take-up lever q is
adjusted as shown in the table below. You may need to adjust this setting depending on the sewing conditions
to prevent the thread from pulling out at the sewing start.
Thread take-up amount (stroke)
q
Loosen the screw w and move the stopper (3.57 nut) e to adjust the operating angle of the thread take-up
solenoid r.
* To reduce the thread take-up amount, move the stopper e upward.
* To increase the thread take-up amount, move the stopper e downward.
NOTE:
Do not increase the stroke of the thread take-up lever any more than is necessary.
If the sub-thread tension is too high, the needle thread length may become too short and the thread may come out of
the needle. Furthermore, if the sub-thread tension is too weak, the needle thread length may become too long and the
underside of the article being sewn may become untidy.
10-7 . Adjusting the movable knife
q
B
Loosen the nut w and move the connecting rod lever e to the left or right to adjust so that the V section A is
aligned with the index bark B on the needle plate when the sewing machine in the stopped position and the
movable knife q is moved toward the index mark.
q
B430E MarkII
spec.
-1,-5
-7
Thread take-
5mm
0mm
up amount
A
LK3-B430E-, B431E-, B432E-, B433E- Mark II
e
Become
less
Become
greater
B431E MarkII B432E MarkII B433E MarkII
-2,-3
–
0mm
5mm
10 . STANDARD ADJUSTMENTS
w
r
-1
-7
5mm
0mm
e
w
34