Adjusting The Thread Take-Up Amount; Adjusting The Movable Knife - Brother LK3-B430E Mark II Service Manual

6-8. Adjusting the thread take-up amount

Thread take-up amount (stroke)
q
At the time of shipment from the factory, the thread take-up amount (stroke) of the thread take-up lever q is
set to the standard setting of 5 mm for ordinary material (-1/-5) ordinary material specifications, and 0 mm for
knitted material specifications. You may need to adjust this setting depending on the sewing conditions to
prevent the thread from pulling out at the sewing start.
[Adjustment method]
Loosen the screw w and move the stopper (3.57 nut) e to adjust the operating angle of the thread take-up
solenoid r.
* The stroke of the thread take-up lever becomes longer when the stopper is moved downward, and it be-
comes shorter when the stopper is moved upward.
NOTE:
Do not increase the stroke of the thread take-up lever any more than is necessary.
If the sub-thread tension is too high, the needle thread length may become too short and the thread may come out of
the needle. Furthermore, if the sub-thread tension is too weak, the needle thread length may become too long and the
underside of the article being sewn may become untidy.

6-9. Adjusting the movable knife

q
B
Loosen the nut w and move the connecting rod lever e to the left or right to adjust so that the V section A is
aligned with the index mark B on the needle plate when the sewing machine in the stopped position and the
movable knife q is moved toward the index mark.
q
A
LK3-B430E Mark II
e
Shorter
Longer
w
e w
6. ADJUSTMENT
r
44