Pulling Up The Bobbin Thread - Brother Innov-ís 2800D User Manual

LOWER/UPPER THREADING
f
After guiding the thread completely through
the groove, pull it toward you to cut it with
the cutter.
a
a
Cutter
g
Attach the bobbin cover by inserting the tab
in the lower-left corner of the bobbin cover,
then lightly press down on the right side of
the cover until it snaps into place.
a
a
Tab

Pulling Up the Bobbin Thread

There may be some sewing applications where you
may want to pull up the bobbin thread, for example,
when making gathers or with free-motion quilting.
Follow the procedure described below to pull up the
bobbin thread.
Memo
Thread the upper thread before pulling up the bobbin
thread. For details, see "Upper Threading" on page 29.
a
Follow steps
section to insert the bobbin into the bobbin
case.
b
Guide the bobbin thread through the groove,
following the arrow in the illustration.
Note
• Do not cut the thread with the cutter.
• Do not attach the bobbin cover.
28
a d
through from the previous
c
While lightly holding the upper thread, press
the "Needle Position" button twice to lower,
then raise the needle.
d
Gently pull the upper thread to pull up the
bobbin thread.
→ A loop of the bobbin thread comes out from the hole
in the needle plate.
e
Pull out about 100 mm (approx. 3-4 inches) of
the bobbin thread, and then pass it under the
presser foot toward the rear of the machine,
making it even with the upper thread.
a
b
a
Upper thread
b
Bobbin thread
f
Attach the bobbin cover.