Saving Stitch Settings - Brother Innov-ís 2800D User Manual

SELECTING A UTILITY STITCH
c
Press

Saving Stitch Settings

This machine is preset with the default settings for the
stitch width (zigzag width), stitch length, thread tension,
automatic thread cutting, automatic reverse/
reinforcement stitching, etc. However, if you wish to
save specific settings for a stitch so that they can be
used later, press
save the new settings with the selected stitch.
Example: Using a stitch length of 2.0 mm for the
straight stitch
a
Select a straight stitch.
Memo
The default stitch length is 2.5 mm.
b
Set the stitch length to 2.0 mm.
52
to go back to the original screen.
after changing the settings to
c
Press .
* To reset the selected stitch pattern to its default
settings, press
→ The confirmation message appears.
d
Press .
Memo
• The next time that the same straight stitch is
selected, the stitch length is set to 2.0 mm.
• All stitch settings (stitch width (zigzag width), stitch
length, thread tension, automatic thread cutting, and
automatic reverse/reinforcement stitching) are
saved, not just the setting that was changed. When
the same stitch pattern is selected, the last settings
saved are displayed even if the machine was turned
off. If the settings are changed again and
pressed, or if
to its default, the new settings are not saved unless
is pressed another time.
• Even if is pressed, the settings for automatic
thread cutting and automatic reverse/reinforcement
stitch cannot be reset.
, and then press .
is
is pressed to reset the setting