NEC NP901W - WXGA LCD Projector Network Setup Manual page 21

3
Set "DHCP".
Check this check box if the network to which the projector is to be connected automatically assigns the
IP address via the DHCP server.
SELECT
<1> Press the
A check will be given if there is no mark found in the box.
• To clear the check box, press the
• If "DHCP" is checked, move the highlight to "ADVANCED" and press the
Proceed to step 9 (
• If "DHCP" is not checked, input "IP ADDRESS", "SUBNET MASK", "GATEWAY", and "DNS
CONFIGURATION" as necessary. After each item has been set, move the highlight to
"ADVANCED" and press the
4
Input "IP ADDRESS".
If "DHCP" is not checked, input the IP address assigned to the projector by the administrator of the
network to which the projector is connected.
<1> Press the SELECT
button.
The software keyboard will be displayed.
<2> Use the SELECT
The characters will be input.
<3> Repeat step <2> above to input the IP address.
• Each button on the software keyboard has the following function.
• "SP" .................. Inputs space.
• "BS" .................. Deletes one character to the left of the character insertion position in the
• " <<" " >>" .......... Moves the character insertion position in the "IP ADDRESS" field to the
• [OK] .................. Finalizes the input character and closes the software keyboard.
• [CANCEL] ........ Cancels the input character and closes the software keyboard.
button once to highlight the "DHCP" check box and press the
page 23). Input "DNS CONFIGURATION" field as necessary.
button. Proceed to step 9 (
button once to highlight the "IP ADDRESS" field and press the
button to select a number to input, and press the
"IP ADDRESS" field.
left or the right.
4. Setting the LAN Setting of Projector
button once again.
button.
button.
page 23).
button.
21
4