Table of Contents
Advertisement
Installing a simple-swap SATA hard disk drive (TD100 models only)
Some server models come with simple-swap SATA hard disk drives that are
accessible from the front of the server. Before you install a simple-swap SATA hard
disk drive, read the following information:
v You must turn off the server before installing simple-swap drives in the server.
v You can install only four simple-swap SATA hard disk drives in the server.
v The sequence for installing the hard disk drives is to install the drives starting
To install a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all external cables
3. Unlock the side cover (you cannot open or remove the bezel without unlocking
4. Remove the bezel (see "Removing the bezel" on page 24.
5. Touch the static-protective package that contains the drive to any unpainted
6. Align the drive assembly with the guide rails in the bay (the connector end of
7. Press the drive assembly loops toward each other; then, carefully slide the drive
38
ThinkServer TD100 and TD100x Types 4203, 4204, 4205, 4206, 6398, 6399, 6419, and 6429: User Guide
Device
Drive bay 11
from the bottom bay (bay 7) and go up to the top bay (bay 4).
on page 20.
and power cords.
the side cover).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
the drive goes in first).
assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
ID
7
Advertisement
Table of Contents
