HP D7171A - NetServer - LPr Installation Manual page 14

defbootstr link="scsi-driver array-driver" Sdsk=array-
driver(0,0,0) Srom=scsi-driver(0,5,0)
for example installing on a NetServer LH, LS, or LX to an HP NetRAID the
command is:
defbootstr link="alad amird" Sdsk=amird(0,0,0)
Srom=alad(0,5,0)
if installing on a NetServer LH, LS, or LX to an HP Disk Array (Mylex) the
command is:
defbootstr link="alad mdac" Sdsk=mdac(0,0,0)
Srom=alad(0,5,0)
The link portion of the above command tells the operating system what BTLD drivers
to use, the Sdsk portion tells the installation which of the controllers on the system
has the boot disk connected to it, and the Srom portion tells the installation which of
the controllers on the system has the CD-ROM connected to it.
NOTE: When using the HP NetRAID Controller, you can safely ignore the
message "WARNING: SCSI boot option(s) ignored: Unknown host adapter
driver".
If you are installing several BTLD packages, the order of these drivers is important
for proper loading from the CD-ROM.
4. When prompted to insert the driver diskette that contains the drivers you specified,
insert the Drivers Diskette.
5. Follow the instructions in the "SCO Installation and Upgrade Guide" to complete
your system installation.
NOTE: For SCO UNIX 3.2v4.2: When the Run Time Installation is complete,
make sure you select the "Install Additional Software" option. This ensures that
the Link Kit is installed and available for later driver integration.
When using SCSI disks larger than 4 GB you must select either "Fully
Configurable Installation" (for UNIX 3.2v4.2) or "Preserve" installation type (for
Open DeskTop and OpenServer). You must then fdisk the physical disk into
partitions that are each 4 GB or smaller.