Overview - HP D7171A - NetServer - LPr Installation Manual

2 Overview

The steps required to install the NetServer in the rack are summarized below:
NOTE This is only a summary; detailed instructions are provided on the
following pages.
Measure and mark the appropriate holes on all four rack columns.
Install three rack nuts on each of the two front rack columns.
Insert one rack nut on each of the two rear rack columns.
Attach the rails to the columns.
Slide the NetServer onto the rails.
Secure the NetServer to the two front columns.
Terms used in this document are defined in the table below.
Term
Rack nut
Rail
Rail mounting flange
Rack (rack enclosure)
EIA unit
Definition
Single nut designed to clip behind the rack column and
accept a screw through the hole in the column
Side bracket which is attached to the rack chassis columns
on which the NetServer is mounted
Mounting flange located at either end of the rail (see Figure
3-3)
The equipment enclosure in which the NetServer will be
installed
Industry standard measurement (1.75 inches / 44.45 mm),
consisting of three vertical mounting holes in a rack column
Introduction
5