Installing The Bezel - HP D7171A - NetServer - LPr Installation Manual

3. Install two screws through the two holes on either side of the NetServer
front panel (see Figure 3-6) and into the rack nuts in the columns
(previously installed).
Figure 3-6. Securing the NetServer to the Rack Columns
4. Replace the hot-swap disk modules into the NetServer.

Installing the Bezel

This NetServer ships with bezel anchors for use with an HP-rack bezel. In
order to install the bezel for use with a Compaq rack, the HP-bezel anchors
must be replaced with Compaq-bezel anchors.
1. Remove the two screws that secure each bezel anchor to each end of the
NetServer front panel, and remove the anchors (see Figure 3-7).
Installation
13