Required Hardware And Software; Hp Netserver Hardware Required - HP D6030A - NetServer - E50 Installation Manual

1 Introducing HP NetServer AutoPilot
When ASR service is enabled, the ASR software periodically notifies the ASR
hardware that the system is running correctly. When the system crashes or hangs,
the ASR hardware stops receiving the OK notices and automatically initiates a
system restart.
NOTE In order for the ASR service to function correctly, the system must be
configured to restart successfully without user intervention.
Be advised, however, that not all system hangs will cause a system restart. For
example, if the network operating system is still functional, but all forms of user
input have been disabled due to error (giving the appearance of a system hang),
ASR will not initiate a system restart.
HP AutoPilot Client Software
HP AutoPilot Client software is installed on a designated workstation (referred to in
this guide as the HP AutoPilot Client). The software is designed to receive and display
notifications and alarms from HP NetServer E Series regarding the server's operational
status.

Required Hardware and Software

The following are required hardware and software components necessary for the
proper installation and operation of HP AutoPilot on both your HP NetServer and HP
AutoPilot Client.

HP NetServer Hardware Required

Minimum server hardware requirements include:
An HP NetServer E Series system connected to the network
For an HP NetServer running Novell NetWare (Version 3.12 or later), you need at
least 500K of unused disk space on the NetWare SYS volume. For an HP
NetServer running Microsoft Windows NT, you need at least 500K of available
disk space on the drive where the operating system is located.
HP Predictive SCSI disk drive failure monitoring supports all HP hard drives that
are factory-installed in HP NetServer E Series systems
10