Telephone Base And Charger Installation; Battery Installation; Battery Charging - VTech CS6419-2 User Manual

Telephone base and charger installation

Install the telephone base and charger as shown below.
Telephone base
power adapter
Electrical
outlet not
controlled by a
wall switch
• Use only the power adapter and battery supplied with this product.
To order a replacement, visit our website at www.vtechcanada.com or
call  (800) 267-7377.
• The power adapter is intended to be correctly oriented in a vertical or
floor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.

Battery installation

Install the battery as shown below.
 Plug the battery connector
securely into the socket.
3 Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
If the handset will not be used for a long time, disconnect and remove the
battery to prevent possible leakage.

Battery charging

Once you have installed the battery, the screen indicates the battery status
(see the table on page 3). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged
after 0 hours of continuous charging. Refer to the online user's manual for
battery operating times.
Telephone
wall jack
Telephone base
If you have DSL
high speed Internet
service, a DSL filter
(not included) is
required.
Electrical
outlet not
controlled by
a wall switch
Telephone
line cord
2 Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
4 Place the handset in the
telephone base or charger
to charge.
CHARGE light
remains on when
charging.
2
Charger adapter
Charger